Wisper 705se Bedienungshandbuch PDF herunterladen (Seite 13)

spacers and washer.

14.3.2.

Install new brake pads, then with both pads pressed against the

wheel rim, ensure that distance-B (in diagram) does not exceed

65mm. To decrease distance-B, exchange wide & narrow spacers on

each brake pad. Before finally tightening brake pads, make sure

they are aligned correctly on the rim, and there is a gap of 1mm

between the top of the rim and the top of the pad. Hold each pad

against the rim (one at a time) & tighten “C” bolt. Final tightening

Torque: 6-8N.M

14.3.3.

Insert cable under bolt “A” , slot cable guide pipe into holder and fit

protector over guide pipe end. Set cable in “A” bolt so that

combined pad/rim clearance (the gaps from left pad to left rim

surface and from right pad to right rim surface) is 2mm, then

tighten “A” bolt. Final tightening torque:6-8N.M.

Balance brake arms by turning “D” screw. Depress brake lever a few

times while checking to see that tension is equal for both arms.

Pad/rim contact should occur at the same time each side. Clearance

should be 1mm each side. Don’t set tension too high.

14.3.4.

Re adjusts pads so they are properly aligned (see step 2), as tension

adjustmentmay have altered original pad alignment.

Disc:

Mechanical disc brakes offer several advantages over traditional rim brakes

better braking in wet, muddy or other adverse conditions, less braking

power

fade over extended downhill braking and the ability to continue braking

even if your rim becomes bent or distorted.

14.3.5. Adjust the pads and caliper

14.3.5.1.

On the disc brake use a 5mm

Allen wrench to adjust the

stationary caliper adjusting bolt at

the back (hub side) of the caliper.

Adjust the bolt so that there is

0.3mm clearance between the

stationary (hub side) pad and the

rotor.

14.3.5.2. Adjust the cable adjuster bolt

on the caliper So that there is

0.3mm clearance between the

outside pad and the rotor.

14.3.6. Installing and removing pads.

Caution: The pads and rotor must be kept

clean and free from oil or grease based

contamination. If the pads become contaminated you

must discard them and replace them with a new set. A

contaminated disc should be cleaned with proprietary

brake cleaning solution.

- 13 -

1 2 ... 8 9 10 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare

Wisper 705se Bedienungshandbuch Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fahrräder Wisper 705se