Wisper 705se Bedienungshandbuch PDF herunterladen (Seite 14)

14.3.6.1.

Holding the pad end-tab, insert it into caliper slot with its

metal backing towards the piston. Make sure the hole in the

metal backing goes over the piston pins. When correctly

inserted, the pad will be held in place magnetically, repeat the

procedure for the other pad.

14.3.6.2.

Pads can be removed by grasping the pad end-tab, lifting the

pad clear of the piston pin and then maneuvering it out of the

rotor slot in the caliper body.

Note: Disc brake pads are held in the caliper magnetically. No tools are

required to install or remove them. As the left and right pads are the

same they maybe inserted on either the left or right of the caliper.

Warning: If you are unsure about any part of the installation process

you should seek advice from Wisper service center or qualified

mechanic.

15 Handle bar stem

15.1 Your bike has been fitted with an adjustable

handlebar clamp that allows you to change the

angle and height of the bars with a 5mm Allen

key to find the most comfortable riding position.

15.2 The stem and handle bars can be adjusted before

you use the bike by slackening bolts A and C along with

the clamp bolt located underneath the adjustable part of

the stem (clamp bolt not shown in the picture). Once a

comfortable position is achieved securely tighten the

clamp bolt located underneath the adjustable part of the stem first so that the

teeth in the serrated clamp plate engage firmly with the adjustable part of the

stem, followed by bolt C. Then securely tighten bolts A evenly. Bolts B should not

normally need to be adjusted or slackened in normal use.

16 The front connection box

16.1 The front connection box allows for the easy removal for repair

or replacement of any of the electronic components on the

handle bars. If opened ensure no wires are trapped between the

two parts when reassembling and do not over tighten the 4

securing screws.

17 Quick release saddle height adjustment

- 14 -

1 2 ... 9 10 11 12 13 14 15 16 17

Keine Kommentare

Wisper 705se Bedienungshandbuch Seite 14