Wisper 705se Bedienungshandbuch PDF herunterladen (Seite 11)

10The ON/OFF button

10.1 When the ON/OFF button is pushed and the capacity indicator lights go

out you have turned the bike “off”. When the bike is “off” you will not get

any assistance from the battery and motor and the bike is effectively

simply an unpowered push bike. To turn the power back on so the pedelec

and throttle work again simply press the ON/OFF button once, the lights

will illuminate showing the power is on.

11The LIGHT button

11.1 The LIGHT button can be found close to ON/OFF button. If you press it

when the bike power is on, the LED headlight on the front fork will

illuminate. Press it again to switch of the light. The power for the light

comes from the bike battery. Due to a low power consumption use of the

light will not reduce your range

12 Pedelec mode and ASSIST mode

12.1 When you first ride your Wisper bike you will notice that after one turn of

the pedals the motor will start working assisting you ride the bike by

adding power to the back wheel. This is the standard or pedelec mode. To

continue using the pedelec mode you must keep turning the pedals, if you

stop pedaling the motor will stop and the bike will slow to a halt. If you

start pedaling again after one turn the motor will start again.

12.2 You will find the ASSIST button on the panel on the handle bars marked

with L.M.H (Low, Medium, High

）

with three corresponding LED’s (small

lights). When the button is pressed sequentially the LED shifts between L

M and H. L means 40% of the maximum power in pedelec mode, M means

80%, and H means 100%.

12.3 High mode is generally used when you need the maximum amount of

- 11 -

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

Wisper 705se Bedienungshandbuch Seite 11